常州导热油泵?常州市武研热油泵有限公司?安装顺序：待混凝土干固后，检查底座和地脚螺栓是否有不良或松动等现象，检查合格后应拧紧地脚螺栓并重新检查常州导热油泵的水平度。校正泵轴和电机轴的同轴度，用验平尺检验时在联轴器外圆上的圆跳动不能超过0.1毫米，两个联轴器平面间的间隙要保证在2-3毫米之间，通过验平尺相差90°对联轴器进行校验时另一方向的圆跳动也不得超过0.1毫米，调节时一般相对于泵来调节电机，可用平板垫的垫入方法来调整联轴器的同轴度。Installation order: do to be solid concrete, check the base and anchor bolt whether there is adverse to loosening, after passing the examination should tighten the anchor bolts and re check the pump level. Calibrated pump shaft and motor shaft coaxial and inspection test ruler in coupling outer circle of the circular runout cannot exceed 0.1 mm, two plane of couplings between the gap to ensure between 2-3 mm, through inspection ruler difference 90 DEG couplet axis device to check another direction round jump move nor more than 0.1 mm, adjust the general with respect to the pump to adjust the motor, available flat pad pad method to adjust the coupling of coaxial degree.
常州市武研热油泵有限公司
地 址：常州市武进区横林镇横玉路247号
销 售：,
售 后：
传 真：
手 机：
: 876363125
邮 箱：WRY@vip.163.com
常州热油泵：www.wry006。。ｃｏｍ
WRY热油泵：www.wry002。。ｃｏｍ
热油泵配件：www.wry008。。ｃｏｍ
离心式热油泵：www.wry003。。ｃｏｍ
友情链接：耐腐蚀化工泵 www.wyryb。。ｃｏｍ
锅炉辅机：www.whboiler。。ｃｏｍ
刮板出渣机：www.cz-boiler。。ｎｅｔ
主动/被动炉排片：www.glfj。。ｎｅｔ
提升式上煤机：www.wh-boiler。。ｃｏｍ
武研导热油泵：http://wrypump.cn.alibaba.com
锅炉辅机配件：http://glboiler.cn.alibaba.com
2015.6.2张
