污水处理设备 污泥处理设备 水处理过滤器 软化水设备/除盐设备 纯净水设备 消毒设备|加药设备 供水/储水/集水/排水/辅助 水处理膜 过滤器滤芯 水处理滤料 水处理剂 水处理填料
上海君翼仪器设备有限公司
上海君翼仪器设备有限公司
韩国KODO NXG-SA超声波发生器特点和参数：*主电源s/w-打开电源按钮，使所有功能就绪。*SWEEP功能-对除气和减少污点（死区）有良好的效果。*运行功能：有功率设定、程序操作、定时器、风机运行温度设定功能。*远程控制功能-远程控制超声波输出。*rs-485通信-通过rs-485通信，用户可以监视和控制plc上的操作。
韩国KODO NXG-SA超声波发生器特点和参数：
•Output Control - Output level can be controlled from 10 to 99%.
•SWEEP Function - Built in Sweep function has a great affect in deaeration and decreasing stain spots (Dead Zone).
•Remote Function - Remote control function using exterior point of contract.
•FND Function - One can easily identify frequency, power, time, and temperature through FND.
•Other Functions - Alarm Function, 4~20mA communication function.
*输出控制-输出电平可控制在10%~99%之间。
·*SWEEP功能-对除气和减少污点(死区)有良好的效果。
·远程功能-使用外部契约点的遥控功能。
·fnd功能-通过fnd可以方便地识别频率、功率、时间和温度。
·其他功能-报警功能、4~20 ma通信功能。
超声波发生器型号 | NXG-SA600 / SA900 / SA1200 / SA1500 / SA1800 |
超声波频率 | 28Khz / 40Khz |
超声波输出功率 | 600W / 900W / 1200W / 1500W / 1800W |
超声波换能器 | B.L.T Transducer |
SWEEP 功能 | O |
控制方法 | Analog Type模拟量 |
尺寸(mm) | 300x400x120 |
电源 | AC220V/60Hz |
重量 | 约12Kg |
韩国KODO NXG-HD高频超声波发生器特点和参数：
•Generator for High-frequency - NXG-HD series is designed for high-frequency from 68Khz to
168Khz.
•Easy of Use - Users can easily control the operation using control panel.
•Self Diagnosis Function - Users can easily figure out the cause of malfunction due to self
diagnosis function.
•DATA Check - One can easily check operation frequency, power, and internal
temperature level without separate measuring instrument.
•RS-485 Communication - Though the RS-485 communication, users can monitor and control
operation on PLC.
•Alarm Function - It alerts the users if there is any problem.
高频超声波发生器型号 | NXG-HD-68K/75K/100K/132K/168K |
超声波频率 | 68Khz/75Khz/100Khz/132Khz/168Khz |
超声波输出功率 | 600W / 900W / 1200W |
超声波换能器 | B.L.T Transducer |
振动方法 | PLL |
尺寸(mm) | 310x440x130 |
输入电压 | AC220V/60Hz |
输入电流 | 6A(at 1200W of output) |
重量 | 约12Kg |
韩国KODO NXG-HSS高速切换三频率发生器特点和参数：
High-speed switching 3-Frequency Generator NXG-HSS
1) By switching the position of the standing wave for three different frequencies at a high speed, it
provides a cleaning power of each frequency at the same time.
2) Because the positions of the standing wave of each frequeny is different.
A.To prevent stains caused by standing waves.
B.It provides precise cleaning, and can also reduce damage to the cleaning tank.
3) The burst wave generated by high-speed switching method creates a number of high-order vibration
to the cleaning of the glass capillary tube and precision parts.
4) Ultrasound of 100Khz is a degassing effect, it is possible to prevent the attenuation of ultrasonic
cleaning power to keep up to near the top of the wash tank.
5) The pumping effect caused by high speed switching(mSec) is effecting washed complex fine holes.
6) The life time of Tank and Transducers increases.
超声波发生器型号 | NXG-HSS |
超声波发生器方法 | Oscillation Mode Choice F1-F2, F1-F3, F2-F3 2 frequency Switching / F1-F2-F3 3 frequency Switching |
切换周期 | 1~10ms Selectable |
超声波频率 | 28K/45K/100Khz |
超声波输出功率 | 600W / 600W / 300W |
超声波换能器 | B.L.T Transducer for Multi Transducer |
输入功率 | Single AC200V ~ AC220V / 60Hz, 4A Max |
显示 | Character LCD(2 * 20) & LED |
输出功率 | 50% ~ 99% |
计时器 | 1sec ~ 99min 59sec |
环境 | Temperature:0~40℃, Humidity 0~80% |
尺寸(mm) | 310x440x130 |
重量 | 约12Kg |
韩国KODO NXG-MD低输出超声波发生器特点和参数：
High-speed switching 3-Frequency Generator NXG-HSS
1) By switching the position of the standing wave for three different frequencies at a high speed, it
provides a cleaning power of each frequency at the same time.
2) Because the positions of the standing wave of each frequeny is different.
A.To prevent stains caused by standing waves.
B.It provides precise cleaning, and can also reduce damage to the cleaning tank.
3) The burst wave generated by high-speed switching method creates a number of high-order vibration
to the cleaning of the glass capillary tube and precision parts.
4) Ultrasound of 100Khz is a degassing effect, it is possible to prevent the attenuation of ultrasonic
cleaning power to keep up to near the top of the wash tank.
5) The pumping effect caused by high speed switching(mSec) is effecting washed complex fine holes.
6) The life time of Tank and Transducers increases.
超声波发生器型号 | NXG-HSS |
超声波发生器方法 | Oscillation Mode Choice F1-F2, F1-F3, F2-F3 2 frequency Switching / F1-F2-F3 3 frequency Switching |
切换周期 | 1~10ms Selectable |
超声波频率 | 28K/45K/100Khz |
超声波输出功率 | 600W / 600W / 300W |
超声波换能器 | B.L.T Transducer for Multi Transducer |
输入功率 | Single AC200V ~ AC220V / 60Hz, 4A Max |
显示 | Character LCD(2 * 20) & LED |
输出功率 | 50% ~ 99% |
计时器 | 1sec ~ 99min 59sec |
环境 | Temperature:0~40℃, Humidity 0~80% |
尺寸(mm) | 310x440x130 |
重量 | 约12Kg |
您感兴趣的产品PRODUCTS YOU ARE INTERESTED IN
环保在线 设计制作，未经允许翻录必究 .
请输入账号
请输入密码
请输验证码
